BuddeMix Stirring System 1-4
This novel stirring system has been conceived to mix low viscosity fluids as well as highly viscous media at slow speeds. Its special design creates inherent dynamic currents to produce perfectly homogeneous mixing results in very little time. Additional components like baffles, bottom bearings, etc. are not needed.
Available on request:
- Your advantages at a glance:
- suitable for low to highly viscous fluids
- stirs media containing solids and fibres without any difficulty
- gentle, low-shear stirring, due to slow stirring speed
- constant product temperature, with no heating effect
- short mixing times as the entire contents of the container are agitated
- no air addition, no foaming
- no baffles required
- low gear wear due to balanced forces
- minimal power consumption thanks to low speeds and short operation times
- easy cleaning
- Particularly for potentially explosive atmospheres:
- a single stirring zone near to the container base ensures easy mixing of settled residues, e.g. in flow-through mixing containers
- no baffles required, thus no additional sources of ignition
Available on request:
- customised shaft length
- fine surface polishing Ra 0.6 to 0.8 µm, except BuddeMix Mini
- certificate of roughness, except BuddeMix Mini
- material certificate 3.1 B
Documents
TypeMaterial
no.Length
mmStirrer Ø
mmShaft Ø
mm
no.Length
mmStirrer Ø
mmShaft Ø
mm
Code: 40 26446 00806 2
not in stock
TypeBuddeMix Mini 30
Material no.1.4404
Length mm350
Stirrer Ø mm35
Shaft Ø mm8
Code: 40 26446 00834 5 not in stock
TypeBuddeMix Mini 40
Material no.1.4404
Length mm350
Stirrer Ø mm46
Shaft Ø mm8
Code: 40 26446 00799 7 not in stock
TypeBuddeMix 1
Material no.1.4404
Length mm350
Stirrer Ø mm60
Shaft Ø mm10
Code: 40 26446 00535 1 not in stock
TypeBuddeMix 2
Material no.1.4404
Length mm350
Stirrer Ø mm80
Shaft Ø mm10
Code: 40 26446 00536 8 not in stock
TypeBuddeMix 3
Material no.1.4404
Length mm550
Stirrer Ø mm120
Shaft Ø mm10
Code: 40 26446 00537 5 not in stock
TypeBuddeMix 4
Material no.1.4404
Length mm850
Stirrer Ø mm150
Shaft Ø mm10
PLR compressed air laboratory stirrers are designed for all kinds of standard mixing tasks. The vane type, air-driven motor offers a high power density and is significantly lighter and smaller than an equivalent electric motor.
No emission of the exhaust air from the housing
GA models feature a separate outlet connection to duct exhaust air away which leads to improved performance at low speed and results in reduced noise levels.
PMR compressed air laboratory stirrers are designed for all kinds of routine mixing tasks. The vane type, air-driven motor offers a high power density and is significantly lighter and smaller than an equivalent electric motor.
No emission of the exhaust air from the housing
GA models feature a separate outlet connection to duct exhaust air away which leads to improved performance at low speed and results in reduced noise levels.
PMR compressed air laboratory stirrers are designed for all kinds of routine mixing tasks. The vane type, air-driven motor offers a high power density and is significantly lighter and smaller than an equivalent electric motor.
No emission of the exhaust air from the housing
GA models feature a separate outlet connection to duct exhaust air away which leads to improved performance at low speed and results in reduced noise levels.
